I need some help and advise on my front forks. Here is the back ground. When I first got the bike to get the axle to fit I had to slide the left fork up just a bit to get it to in there smoothly. Since I am installing the Toaster Tan top clamp with my dual disc set up I thought I would check out the left fork leg. Needless to say I had some issues and I had to take the inners out of the leg. What I have in my hand doesn't match the fisch, I seem to be missing stuff so I need some help in determining what is missing. The picture is deceiving in that it shows a bunch of parts under the spring that as far as I can remember are at the bottom of the tube. There also shows more parts that I got when I removed the end pieces from the bottom of the tube. Next issue is on item 14, the spring or whatever was on there got broken and I need to replace, again it shows more parts then were what was on top of it when I removed it.
Stuff that is different are:
bottom of tube I have 11 the clip, threaded ring 10, spacer 9 , another threaded ring and that is the end of those parts, missing 7 and 10.
On the top of 18, the pipe missing 13 those three rings, need 14 as the wiper is broken, then I just have another ring 9 and the spring 17, missing 15 and 16, same on both of them.
At least I didn't spring for new ones and discovered that mistake.
