Boxerworks.com

That's good to hear Grant.
The bike looks sweet.

Is that a sheep or a polar bear on the seat?

Jeff,

Mate now that the seafood stocks are depleting and the warmer weather is hanging around a little longer I stumbled across this juvenile polar bear skin on Ebay, there a little more readily available now as you would understand, postage was a little $$$$ even for a juvenile but the thought of that cost soon faded away once I got it all unwrapped and tried it out... very nice and comfy....




sheep mate, had it for 25 years!!

Hide those skinny fork tubes with gaiters.

Zombie Master wrote:Hide those skinny fork tubes with gaiters.

Yeah!



¿Qué?

Rob wrote: ¿Qué?

Canadian Club, I'd say.

Wot! No rocker cover bolt! Go to the corner!

SteveD wrote:Wot! No rocker cover bolt! Go to the corner!

Shit where the hell are they or did they go?

I know I was laying the knee down a little fanging over through the hills but that's just getting a little to low for me.

Doyle did you pinch'em did'ya, you've been lurking around my shed a little these past few weeks

grant81rs wrote:

SteveD wrote:Wot! No rocker cover bolt! Go to the corner!

Shit where the hell are they or did they go?

I know I was laying the knee down a little fanging over through the hills but that's just getting a little to low for me.

Doyle did you pinch'em did'ya, you've been lurking around my shed a little these past few weeks

I recommend strong thread locker on the head end of the stud.

Or, you could just epoxy them to the head cover. I gave up trying to actually use mine. The two side nuts held everything tight.

Here, let me spend some of your money!

http://www.bmw2valve.com/motorcycle/1112265.html



You can buy them singularly. If you don't want the oil filler, just buy two without. They fit either side (in/ex).
(but you need a real center stud, then. Ask ZM, he may be available!)