Page 1 of 1
Loctite product for rear drive to swingarm Mono R100RS with no gasket
Posted: Thu May 26, 2022 9:27 am
by beemered
Anyone have the factory recommendation for this application?
thanks,Ed
Re: Loctite product for rear drive to swingarm Mono R100RS with no gasket
Posted: Fri May 27, 2022 11:17 am
by gspd
Not sure exactly what you're asking.
Almost any sealer (or grease) should be suitable for this low stress area.
I always thought there was a gasket between the arm and the rear drive.
Re: Loctite product for rear drive to swingarm Mono R100RS with no gasket
Posted: Fri May 27, 2022 4:05 pm
by Rob Frankham
It surprised me as well... I've always fitted final drives with a gasket but when I checked the parts list I found that Monos aren't specified with a gasket at that location. This is confirmed by the 'Parts Use' listing which shows them only for machines up to '84. Can't see that it makes a great deal of difference really whether you fit a paper gasket or use a sealant. I guess just about any instant gasket would do the job...
Rob
Re: Loctite product for rear drive to swingarm Mono R100RS with no gasket
Posted: Tue Jun 28, 2022 5:21 pm
by pxc433
I recently had to replace my driveshaft (97K miles and the UJ had become notchy). On reassemlby I used Hylomar Blue sparingly and so far not a trace of oil.