Page 1 of 4
Browns side stand install
Posted: Wed Aug 04, 2010 2:38 am
by Zombie Master
1984 R100S: Ordered one from Bob's at the Redmond rally. Just came in today. Instructions are confusing. It talks about attaching to the foot peg bolt. That makes no sense, on my model the foot peg bolt is directly under the swing arm pivot. There are two attachment holes on the stand. It looks to me that one would attach to the rear frame bolt after relocating the header pipe hanger to the
forward hole on the stand.
Can't say that I like the idea of putting any stress on the exhaust system though.
Any thoughts on this install?
Re: Browns side stand install
Posted: Wed Aug 04, 2010 4:21 am
by SteveD
Re: Browns side stand install
Posted: Wed Aug 04, 2010 4:22 am
by SteveD
Edit! We need edit!
Re: Browns side stand install
Posted: Wed Aug 04, 2010 7:16 am
by Deleted User 72
You surmise correctly. The thing bolts to the rear engine mount bolt, which is where the footpeg bolts on my bike. Hanger is reversed, etc. No undue strain is palced on the exhaust.
Re: Browns side stand install
Posted: Wed Aug 04, 2010 7:18 am
by Deleted User 72
"No undue strain is palced on the exhaust." Ha!
No undue strain is placed on the exhaust.
EDIT!!! We need EDIT!
Re: Browns side stand install
Posted: Wed Aug 04, 2010 7:25 am
by Deleted User 72
Besides, its your CENTER stand that's sacked! (That's the one with too legs.)
Re: Browns side stand install
Posted: Wed Aug 04, 2010 7:44 pm
by Oldcolt72
too legs?
Two legs?
Re: Browns side stand install
Posted: Wed Aug 04, 2010 9:44 pm
by Zombie Master
You guys!
Re: Browns side stand install
Posted: Wed Aug 04, 2010 10:20 pm
by Major Softie
I think he's just trying to reinforce that:
EDIT!!! We need EDIT!
Re: Browns side stand install (EDIT BUTTON)
Posted: Thu Aug 05, 2010 8:56 am
by George Ryals
In the FAQ section it says there is an edit button BUT I can't find it!
