Page 1 of 1
Circuit board help
Posted: Tue May 27, 2014 4:28 pm
by zeroweaver
I have a 1975 R75/6 and I need a little info on the circuit board. So...there are either 1, 2, or 3 pairs of connectors for each color on the circuit board. Do all the colors have matching wires that just plug right in to it corresponding color?
Re: Circuit board help
Posted: Tue May 27, 2014 4:43 pm
by richard t
correct if none of the wiring has been changed.
Re: Circuit board help
Posted: Tue May 27, 2014 5:08 pm
by dwerbil
Re: Circuit board help
Posted: Tue May 27, 2014 8:08 pm
by melville
I have the same bike and I was able to make it all work just fine after taking the headlight shell completely apart for paint. Just plug 'n' play, provided the PO hasn't dicked too terribly much with the wiring.
Re: Circuit board help
Posted: Wed May 28, 2014 11:47 am
by zeroweaver
Thanks for the wiring diagram!
Re: Circuit board help
Posted: Wed May 28, 2014 1:35 pm
by Bamboo812
Just a reminder, it is possible to mount the wires to the board incorrectly if the male spade on the board gets jammed between the female plug and its plastic/rubber cover. It may work for a while, but vibration will cause the connection to fail, leading to much head scratching trying to figure it out.
Re: Circuit board help
Posted: Fri Jun 06, 2014 11:53 am
by zeroweaver
Thanks. I saw that very thing just the other day.