Page 1 of 1
Lost Flywheel??
Posted: Sun Dec 06, 2015 7:33 pm
by chasesa
Hi
Trying to set valves on RT for first time since purchase and cannot see the flat surface of the
flywheel to get the OT mark to appear after at least a full revolution.
Looking through the hole toward the front I can see the teeth of the clutch housing wheel.
I performed clutch spline lube and re-assembled the transmission to
motor case. It went together easily.
Could I have pushed the flywheel ahead?
Ideas, please & thanks. I have 3 other airheads, never had such an issue!
Stephen C
Re: Lost Flywheel??
Posted: Sun Dec 06, 2015 11:36 pm
by Bamboo812
What year bike? '81 and later have a clutch carrier and those marks are on small tabs and are easy to miss. Set the piston to top dead center, and the mark should be in the window, or nearly so. Note: the "OT" mark was replaced with a "Z" at some point. Does anyone know when?
Re: Lost Flywheel??
Posted: Mon Dec 07, 2015 1:49 am
by ME 109
Bamboo812 wrote:What year bike? '81 and later have a clutch carrier and those marks are on small tabs and are easy to miss. Set the piston to top dead center, and the mark should be in the window, or nearly so. Note: the "OT" mark was replaced with a "Z" at some point. Does anyone know when?
my 81 has OT and Z. Sounds odd to relocate Z to OT. There's a whole alphabet to choose from!
BMW could have used 'Ha'.
Ha, missed me!
Re: Lost Flywheel??
Posted: Mon Dec 07, 2015 10:49 am
by jimmyg
if your bike has a lightened (modified) flywheel, don't expect to see those marks.
I installed a light flywheel on my R90s and had to make my own marks before installation.
jimmyg
Re: Lost Flywheel??
Posted: Mon Dec 07, 2015 1:06 pm
by Bamboo812
ME 109 wrote:Bamboo812 wrote:What year bike? '81 and later have a clutch carrier and those marks are on small tabs and are easy to miss. Set the piston to top dead center, and the mark should be in the window, or nearly so. Note: the "OT" mark was replaced with a "Z" at some point. Does anyone know when?
my 81 has OT and Z.
Are you saying the Z mark replaces the F mark on later flywheels (clutch carriers)?
Re: Lost Flywheel??
Posted: Mon Dec 07, 2015 1:46 pm
by ME 109
Bamboo812 wrote:ME 109 wrote:Bamboo812 wrote:What year bike? '81 and later have a clutch carrier and those marks are on small tabs and are easy to miss. Set the piston to top dead center, and the mark should be in the window, or nearly so. Note: the "OT" mark was replaced with a "Z" at some point. Does anyone know when?
my 81 has OT and Z.
Are you saying the Z mark replaces the F mark on later flywheels (clutch carriers)?
Yes.
Re: Lost Flywheel??
Posted: Mon Dec 07, 2015 2:36 pm
by Bamboo812
Alrighty then, Haynes was not too specific about that...