Oilhead Special Tools
Posted: Thu Jan 07, 2016 2:13 pm
Doing some maintenance on my '04 RT this winter and I'm in the middle of replacing the Paralever bearings in the rear end.
I need to hold the inner pin with a 12mm hex wrench while doing the final torque on the locknut and was wondering if anyone makes a special tool to hold the adjustment pin from turning while torquing the nut?
I envision a 30mm deep dish socket (1/2" drive) that has a portion cut-out to insert the allen so it can be held.
Or would I just have to make one myself?
thanks,
jimmyg
I need to hold the inner pin with a 12mm hex wrench while doing the final torque on the locknut and was wondering if anyone makes a special tool to hold the adjustment pin from turning while torquing the nut?
I envision a 30mm deep dish socket (1/2" drive) that has a portion cut-out to insert the allen so it can be held.
Or would I just have to make one myself?
thanks,
jimmyg