This guy is good. He does say "fuck" a lot, probably because he's an Aussie.
https://www.youtube.com/watch?v=692kYQN8q5Q
"Dustbin" fairing anyone?
-
Airbear
- Posts: 2886
- Joined: Tue Aug 03, 2010 10:02 am
- Location: Oz, lower right hand side, in a bit, just over the lumpy part.
"Dustbin" fairing anyone?
Charlie
and Brunhilde - 1974 R90/6
Graduate, Wallace and Gromit School of Engineering and Design (Pending)
and Brunhilde - 1974 R90/6
Graduate, Wallace and Gromit School of Engineering and Design (Pending)
-
Zombie Master
- Posts: 8821
- Joined: Sun Aug 22, 2010 12:21 am
- Location: Vancouver Island BC Canada
Re: "Dustbin" fairing anyone?
- IMGP0105.JPG (220.2 KiB) Viewed 1887 times
This was my restoration.
Any and all disclaimers may apply
-
Sibbo
- Posts: 5637
- Joined: Fri Aug 06, 2010 3:18 am
- Location: Oz , half way up ,sitting on a wet spot .
Re: "Dustbin" fairing anyone?
He's brilliant at metal forming ! I'm jealous, that's a skill I'd love to have. I'd have to build a fairing from glass and epoxy, probably over a foam former.
"You ain't gonna learn what you don't want to know"
The Grateful Dead
The Grateful Dead
Re: "Dustbin" fairing anyone?
No not me. I have hammered out a couple dustbins and several tanks,seats,and other stuff in aluminum. The guy does good work.---RG
Re: "Dustbin" fairing anyone?
No not me. I have hammered out a couple dustbins and several tanks,seats,and other stuff in aluminum. The guy does good work.---RG