Diameter size of the forks on a mono shock??

[robtg]

Dougie wins it. 38.6
Where did someone come up with "same a K bike" ??
sheesh, the inernet is dangerous

More interesting to me would be to know how BMW arrived at 38.6mm?

Well, it's a nominal 1-1/2"

38.6mm = 1.519682" About a 1/2mm over 1/2". 38mm is more like a "nominal" 1/2". Just to be nit picking.

[SteveD]

Dougie wins it. 38.6
Where did someone come up with "same a K bike" ??
sheesh, the inernet is dangerous

Hey, I had a ? after it!

[Major Softie]

38.6mm = 1.519682" About a 1/2mm over 1/2". 38mm is more like a "nominal" 1/2". Just to be nit picking.

Well, if we're going to pick nits, a "nominal" 2x4 is approximately 1.5" x 3.5", so if 2" gets granted 1/2" of latitude, I think I should be granted a 1/2 a millimeter on 1-1/2".

[Deleted User 287]

38.6mm = 1.519682" About a 1/2mm over 1/2". 38mm is more like a "nominal" 1/2". Just to be nit picking.

Well, if we're going to pick nits, a "nominal" 2x4 is approximately 1.5" x 3.5", so if 2" gets granted 1/2" of latitude, I think I should be granted a 1/2 a millimeter on 1-1/2".

I can see that working:

[robtg]

38.6mm = 1.519682" About a 1/2mm over 1/2". 38mm is more like a "nominal" 1/2". Just to be nit picking.

Well, if we're going to pick nits, a "nominal" 2x4 is approximately 1.5" x 3.5", so if 2" gets granted 1/2" of latitude, I think I should be granted a 1/2 a millimeter on 1-1/2".

Ok fine, take your damn half a millimeter.

[Major Softie]

Ok fine, take your damn half a millimeter.

HA!

[robtg]

Ok fine, take your damn half a millimeter.

HA!

HA!........HA!????.....I take my half a millimeter back Sir and bid you good day.

[Deleted User 62]

Ok fine, take your damn half a millimeter.

HA!

HA!........HA!????.....I take my half a millimeter back Sir and bid you good day.

I hope you guys don't stay mad at each other furlong...

[ME 109]

A measured response Tim, I like it.