Page 1 of 1
Cool New Tool from Cycle Works
Posted: Thu Aug 26, 2010 1:10 am
by Deleted User 62
Just perusing the Cycle Works website and found this in the Airhead 1970-95 Tools section:
http://www.cycleworks.net/index.php?mai ... cts_id=367 ...a new tool for pulling and installing the timing cover and the timing gears and bearing, without heating and beating. Like the caption says, put away that hammer!
Re: Cool New Tool from Cycle Works
Posted: Thu Aug 26, 2010 3:24 am
by Zombie Master
I'm working on not being attached. You're not helping!
Heat is your friend
Posted: Thu Aug 26, 2010 6:48 am
by gspd
The odd time heat is required to remove the crank gear even when using the proper BMW puller.
No tools are required to install a properly heated crank gear, they usually slide right on.
Re: Cool New Tool from Cycle Works
Posted: Thu Aug 26, 2010 3:01 pm
by Curt Henry
You get lots of washers and bolts with the tool for only $144.
Re: Cool New Tool from Cycle Works
Posted: Thu Aug 26, 2010 5:31 pm
by Deleted User 61
Curt Henry wrote:You get lots of washers and bolts with the tool for only $144.
I'm betting a lot of that $144 has to do with that fancy split piece with the cut-outs.
Re: Cool New Tool from Cycle Works
Posted: Tue Aug 31, 2010 5:13 am
by Armaguidon13
Nice tool... But complicated and real expensive